Rode VideoMic Pro Rycote Microphone (Open Box)


  • Non Returnable
  • Unused Product
  • Sound Field : Mono
  • Polar Pattern: Supercardioid
  • Windscreen : Foam (Included)
  • Output Connectors : 1 x 1/8″ / 3.5 mm TRS
  • Battery Type : 1 x 9 V

Only 2 left in stock

Free Shipping All Over India

  • Genuine Products & Fast Support
  • Trusted Camera Store For More Than 20 Years
  • Normally Delivery Takes 1 – 7 days
  • For More Queries Check – Customer Help
Guaranteed Safe Checkout

Rode VideoMic Pro Rycote Microphone (Open Box)

In The Box

  • VideoMic Pro Rycote Microphone


  • Shotgun Mic with Directional Sound Pickup
    Whereas most built-in camera microphones pick up sound from all directions, this microphone utilizes a supercardioid polar pattern to focus on sound in front of it while attenuating sound from the sides and rear. Its low-noise electronics and sensitive condenser element deliver more detailed audio than the mics typically found in cameras and portable recorders.
  • Easy Hookup to Camera
    A straight 3.5mm cable is permanently attached to the mic for fast hookup to your camera. The cable’s 3.5mm TRS plug is wired in a dual-mono configuration, ensuring that the mic signal is sent identically to both input channels of your camera or portable recorder.
  • Long Battery Life
    Pop a 9V battery in the VideoMic Pro for up to 70 hours of operating time. The dedicated power LED changes from green to red when the battery should be replaced. The VideoMic Pro can still function for approximately 10 hours once the power indicator turns red, but performance will be compromised. Use the power switch to conserve battery life during periods of inactivity.
  • Bass Roll-Off
    The high-pass filter can be set to flat or 80 Hz to roll off low-frequency noise from common sources such as air conditioners and traffic.
  • 3-Stage Gain Control
    To enable optimal recording levels, the VideoMic Pro boasts a 3-stage gain control. Like the low roll-off and high-frequency boost, the gain control is digitally switched for precision and convenience. The +20 dB setting is ideal when recording to cameras, as it boosts the signal without requiring extreme gain on the camera’s inferior preamp. Select the flat setting when routing the mic into a dedicated high-quality preamp, or switch to the -10 dB option when loud sound sources threaten to distort your recording.
  • Integrated Shockmount Inhibits Vibrations
    Understanding that the rubber bands used in many shockmounts can snap and stretch, Rode chose to integrate a rugged Rycote Lyre suspension-style shockmount. This simplifies setup of the mic and inhibits the transfer of vibrations from the camera. Plus, the bottom of the shockmount features a camera shoe mount with a 3/8″ thread, ensuring easy attachment to your camera or a boompole such as Rode’s Micro Boompole (available separately).
  • Windscreen Minimizes Wind Noise
    The VideoMic Pro has a foam windscreen to reduce unwanted wind noise from breezes, fans, heaters, and air conditioners. For maximum reduction of wind noise in outdoor environments, consider a furry windshield such as the Rode DeadCat VMPR (available separately).
  • Connectivity Options
    Expand the microphone’s device compatibility with Rode accessories such as the SC4 and VXLR (both available separately). The SC4 is a short cable that lets you connect the VideoMic Pro directly to a smartphone or tablet equipped with a 3.5mm TRRS jack. The VXLR adapter is the ideal solution when you want to record the VideoMic Pro to a camcorder or mixer that has XLR inputs.


Form Factor : Stand/Boom Mount
Sound Field : Mono
Operating Principle : Line Gradient
Capsule : Electret Condenser
Diaphragm : 0.5" / 12.70 mm
Polar Pattern : Supercardioid
Orientation : End Address
Circuitry : Solid-State (JFET)
Pad : None
High-Pass Filter : 80 Hz
Tone Adjustment : None
Gain Adjustment : -10 dB to +20 dB
Indicators : 1 x Single LED (Power)
On-Board Controls : Gain, High-Pass Filter, On/Off
Windscreen : Foam (Included)

Frequency Range : 40 Hz to 20 kHz
Maximum SPL : 134 dB SPL
Off-Axis Rejection :
2 dB at 60°
18 dB at 120°
10 dB at 180°
Impedance : 200 Ohms
Sensitivity : -32 dBV/Pa at 1 kHz
Output Level : 6.9 dBu (Max)
Dynamic Range : 120 dB
Signal-to-Noise Ratio : 80 dB
Equivalent Noise Level : 14 dB A-Weighted

Output Connectors (Analog) : 1 x 1/8" / 3.5 mm TRS
Number of Conductors : 2
Wireless Connectivity : None

Operating Voltage : 9 V (Battery Power)
Operating Current Consumption : 7.8 mA
Battery Type : 1 x 9 V
Approximate Battery Life : 70 Hours

Color : Black
Mounting : 3/8"-16 Female, Camera/Shoe-Mount, Shockmount (via Integrated Hardware)
Dimensions : ø: 3.94 x L: 6.69" / ø: 100 x L: 169.93 mm
Weight : 3 oz / 85 g

Ask Your Query

Product Inquiry